Parallel and in a straight line: two-sided cutting of veneer packages with top and bottom knife.
Anything, just no halfway measures. The KUPER ZFS cuts veneer packages on both sides with a top knife and a bottom knife. The veneer package is placed on the machine table against the limit stop. The guide light here clearly shows the rear cutting line and the optimization laser shows the front cutting line. Kuper precise. After entering the cutting width, the programmed cutting cycle is executed: And we’re off. The table moves to cutting position, the pressure bar clamps the veneer package, which is now cut ready for jointing by the top knife and the bottom knife. Then the table returns to its alignment position.
KUPER POWER for your business.
High-Speed Positioning Drive.
To vary the width dimensions, the machine table with the bottom knife can be adjusted by a high-speed positioning drive. A pressure bar clamps the veneer package, then the top knife cuts downward toward the table, the bottom knife cuts upward toward the pressure bar. The stability of the machine ensures secure collection in the event of high pressing and cutting forces.
Rough Cut Option.
With the aid of the rough cutting device thick veneers can be cut even more precisely. A rough cut and a finishing cut prevent breakouts at the bottom sides of the veneer.
|Insertion height||80 mm|
|Cutting range||20 – 470 mm|
|Pressure bar||3 Hydraulic cylinders, 2 pressure stages|
|Top knife||brake motor, gearing, crank drive|
|Bottom knife||1 hydraulic cylinder|
|Operating voltage standard||400 V, 3 Ph, 50 cycl. or special voltage|
|Total connected load||approx. 10.5 kVA|
|ZFS 2800||2,810 mm|
|ZFS 3200||3,210 mm|
|ZFS 3800||3,810 mm|
Additional technical data upon request. Illustrations may contain options. Additional components such as control cabinets, safety facilities e.g. are maybe not shown. Subject to design modification.