KUPER TFS 3100 - System Casati

Twin Power. Two razor sharp blades cut veneer straight and parallel at the same time. Simply twice as good!

Function KUPER TFS 3100 – System Casati

With the KUPER TFS 3100 - System Casati its possible to cut the veneer bundle from both sides at the same time with two knifes in a single step. The top knife (K1) has its position on the pressure bar (P), the bottom knife on the moveable table (T). The machine has a pressure bar (P) to fix the bundle during the cutting. The movement of the knife (K1) is from top to bottom while the knife (K2) moves in the opposite direction.

Process

At first the cutting width is set up with the keypad. Afterwards the veneer bundle is passed on the table and the width is defined using the optimization laser. The machine performs the following steps:

  • Positioning of the moveable table
  • Downturn of the pressure bar
  • Cutting motion of the two knifes at the same time
  • Lifting up the pressure bar

The machine has an electronical microprocessor-controlled positioner which saves about 2000 cutting dimensions.

Advantages

  • Perfect parallelism of the trimmed sides
  • Adjustable optimization laser and electronical measurement for the optimization of the width
  • The cutting line is indicted by a guide light
  • Surfaces made of low-wear material
  • Adjustable rear fence
  • Strong and compact steel construction
  • Roller guides and ball-bearing spindles
  • Automation via numeric control system
  • TFT 15’ Touch Screen

openTechnical data KUPER TFS

Technical data

Cutting lengthmax. 3100 mm
Insertion height80 mm
Cutting range18 – 350 mm
Pressure barhydraulic
Top knifehydraulic
Bottom knife hydraulic
Operating voltage400 V, 3 Ph, 50 cycl.
Total connected loadapprox. 7,1 kVA


Download

Here you can download the brochure as PDF file.
» KUPER brochure KUPER TFS 3100 - System Casati, Double Knife Veneer Guillotine

Cuts of highest quality

Straight and parallel cutting of the veneers – Maximum precision in cutting ensures the tight-joint splicing after the cut for all kinds of veneer.

Visible marking of cutting line

Clearly visible marking of the cutting line by means of a guide light. Occupational safety regulations are met by a light barrier safety device, two-hand operation, electric safety control system and protective gratings at the rear.

Easy operation

Telescreen positioning control system fordiverse modes of operation and storableprogram operations.

Less veneer scrap

An adjustable optimization laser reduces the amount of veneer scrap.

Saving of time

The machine has a cutting capacity of approximately 2 to 3 packs per minute. This includes inserting, aligning, cutting and removing the veneer.

Additional technical data upon request. Illustrations may contain options. Additional components such as control cabinets, safety facilities e.g. are maybe not shown. Subject to design modification.