KUPER FAZ 100 System Josting

Low-noise chopping machine for waste veneer strips with the KUPER FAZ.

The KUPER FAZ is a low-noise chopping machine for waste veneer strips and veneer pack trimmings. Veneer scrap, produced in the course of cutting veneer to size, can be put to profitable use as a heating fuel. Conventional rotary refuse grinders are unsuitable, however, for the chopping of veneer (high level of noise, veneer stripes become tangled).

Machine loading and unloading can be adapted to the specific conditions of production. A vacuum extractor unit can be installed on the slide. Chopping reduces the volume of the waste by about half, i.e. chopped veneer waste needs about 50 %less space for transporting and storage. It is an advantage to use a long feed conveyor to collect the veneer waste from several cutting machines. The chopping machine ’s conveyor can be lowered on request to enable near-floorlevel feeding.

The veneer waste is put on the chopping machine ’s conveyor, which transports it to the cutting zone in stepping mode. Chopping is performed by a crossblade and 10 longitudinal blades working against a cutting bar in continuous up-and-down operation. The KUPER FAZ features a powerful knife drive system with brake motor, gearing and lateral crank drives. Hood guards prevent accidents, and a rupturing diaphragm device protects the machine from overloading.

openTechnical data KUPER FAZ

Cutting width x cutting height 700 x 90 mm
Conveyor area 2320 x 700 mm
Step measure of conveyor10 – 25 mm
Step measure of conveyor (without longitudinal knives)50 mm
Step measure of conveyor3 – 4 m3 per hour
Operating voltage standard 400 V, 3 Ph, 50 cycl. or special voltage
Total connected loadapprox. 6,5 kVA

Additional technical data upon request. Illustrations may contain options. Additional components such as control cabinets, safety facilities e.g. are maybe not shown. Subject to design modification.