KUPER ZFS.
Parallel and in a straight line: two-sided cutting of veneer packages with top and bottom knife.
Anything, just no halfway measures. The KUPER ZFS cuts veneer packages on both sides with a top knife and a bottom knife. The veneer package is placed on the machine table against the limit stop. The guide light here clearly shows the rear cutting line and the optimization laser shows the front cutting line. Kuper precise. After entering the cutting width, the programmed cutting cycle is executed: And we’re off. The table moves to cutting position, the pressure bar clamps the veneer package, which is now cut ready for jointing by the top knife and the bottom knife. Then the table returns to its alignment position.
KUPERPOWER for your business.
High-Speed Positioning Drive.
To vary the width dimensions, the machine table with the bottom knife can be adjusted by a high-speed positioning drive. A pressure bar clamps the veneer package, then the top knife cuts downward toward the table, the bottom knife cuts upward toward the pressure bar. The stability of the machine ensures secure collection in the event of high pressing and cutting forces.
Precision Cut Option:
With the aid of the precision cutting device thick veneers can be cut even more precisely. A rough cut and a precision cut prevent breakouts at the bottom sides of the veneer.
Visible marking of cutting line
Clearly visible marking of the cutting line by means of a guide light.
Cuts of highest quality
Straight and parallel cutting of the veneers – Maximum precision in cutting ensures the tight-joint splicing after the cut for all kinds of veneer.
Swinging and powerfull drawing motion
Cuts of highest quality thanks to the swinging and powerfull drawing motion of the knife at an angle of approx. 20°.
Easy operation
Telescreen positioning control system fordiverse modes of operation and storableprogram operations.
Less veneer scrap
An adjustable optimization laser reduces the amount of veneer scrap.
Time saving
The machine has a cutting capacity of approximately 2 to 3 packs per minute. This includes inserting, aligning, cutting and removing the veneer.
Technical data.
| Insertion height | 80 mm |
| Cutting range | 20-470 mm, 20-700 mm |
| Pressure bar | 3 Hydraulic cylinders, 2 pressure stages |
| Top knife | brake motor, gearing, crank drive |
| Bottom knife | 1 hydraulic cylinder |
| Operating voltage standard | 400 V, 3 Ph, 50 cycl. or special voltage |
| Total connected load | approx. 10.5 kVA |
Cutting length
| ZFS 2800 | 2,810 mm |
| ZFS 3200 | 3,210 mm |
| ZFS 3800 | 3,810 mm |
Additional technical data upon request. Illustrations may contain options. Additional components such as control cabinets, safety facilities e.g. are maybe not shown. Subject to design modification.
Do you have any questions?
- Klaus Schlütermann
Sales Manager - +49 52 44/9 84 - 3 42
- klaus.schluetermann@KUPER.de